 |
Replacement central vacuum powerhead belts that will fit many different models. Replacing the belt helps increase the drive ability of your brush roll which, in turn, keeps your floors and home cleaner. The manufacturer recommends replacing the belt every six months to ensure optimum performance.
Includes two(2) belts per package.
Will fit the following powerheads:
- BEAM
- Aero III / Butler / Classic
- BM1365
- BM1386
- RugMaster
- Eureka
- Filtex
- Frigidaire
- Honeywell
- NuTone
Tools required:
- Philips #2 Screwdriver
- Needle-nose Pliers (Installation Method 1)
- Flathead Screwdriver (Installation Method 2)
Step 1: Remove the 2 Phillips #2 screws from the bottom (underside) of the powerhead base
Step 2: Remove the hood
Step 3: Remove 2 Phillips #2 screws from the brush roll cover
Step 4: Remove brush roll cover
Step 5: Remove brush roll and old belt, throw away old belt
Step 6: Inspect brush roll and check to see if it spins freely, if not you are advised to replace this part
Step 7: (Method 1) Put belt around brush pulley, then around motor shaft
Step 8: (Method 1) Place the round end cap of the roller into the round slot in the nozzle housing
Step 9: (Method 1) Pull the pulley end and guide it into the housing slot and guide it into place with the pliers
Step 7: (Method 2) Put the belt over the pulley end of the brush roll
Step 8: (Method 2) Place the bush roll back into the nozzle housing making sure both ends are securely in place
Step 9: (Method 2) Pull the belt back over the motor shaft using your Flathead screwdriver
Step 10: Ensure the brush roll spins freely and the belt is not pinched between the roller and housing
Step 11: Install brush roll cover
Step 12: Install 2 short Phillips #2 screws to secure the brush cover in place
Step 13: Install Hood
Step 14: Install 2 long #2 Phillips #2 screws to secure hood in place
Step 15: Vacuum your home to ensure that your repair was a success
Step 16: Reward yourself for a properly executed repair and a freshly cleaned home
|
|
|
Belts 
